EEVblog Electronics Community Forum

Electronics => PCB/EDA/CAD => Circuit Studio => Topic started by: pisoiu on December 15, 2020, 02:57:29 pm

Title: Interactive routing visibility problems
Post by: pisoiu on December 15, 2020, 02:57:29 pm
I am sorry if this has been discussed here before, I was not able to find it.

While I am doing interactive routing I have some visibility problems. When I choose a net to work on, all other nets/vias disappears from my view, I cannot see them. I can only guess where they are after the shadows they make over the grids. It is very difficult to work this way.

I spent a fair amount of time looking for a solution in settings but no luck so far. How can I change this? In CS tutorials I saw that the other nets/vias/tracks only dim their color, but they do not disappear completely like in my case. I attached 2 pictures, one with normal view, other with interactive routing started.
Title: Re: Interactive routing visibility problems
Post by: IanJ on December 15, 2020, 03:49:38 pm
Go to VIEW tab (on PCB) and at the right hand side of the ribbon set the DIM level slider. You probably have it quite low.

Ian.
Title: Re: Interactive routing visibility problems
Post by: pisoiu on December 15, 2020, 09:00:35 pm
Thanks very much, it worked.