Is there the ability in CS to set polygon pour priorities? I can do it in Eagle easily, and it seems the full Altium has an option to create priorities where pour areas overlap.
I had some polygons on a layer all doing their thing, then put a layer wide pour on to make a ground fill, and it simply stomps over all the smaller pours. Also it seems these smaller pours get set to 'un-poured' and no matter what I do to turn them back on they are set like that. So it looks like in CS the ability to have overlapping polygons doesn't seem to be work, or has been crippled. I would be very glad to hear if this is not the case!