Author Topic: Problem with Vault  (Read 3013 times)

0 Members and 1 Guest are viewing this topic.

Offline ahbushnellTopic starter

  • Frequent Contributor
  • **
  • Posts: 732
  • Country: us
Problem with Vault
« on: March 07, 2017, 12:41:53 am »
I searched for a TL431AIDBZR shunt regulator and found it in the vault.  I than placed the component in the schematic and all seemed well.  I noticed that I couldn't move the component I clicking and dragging.  :<.  I found I could move it using the move command under the tools.  Why is this different than other components.  While placing the component I put down one too many.  Now I can't figure out how to delete it? 

Suggestions?

 

Offline ahbushnellTopic starter

  • Frequent Contributor
  • **
  • Posts: 732
  • Country: us
Re: Problem with Vault
« Reply #1 on: March 07, 2017, 04:24:53 am »
I figured out the problem.  There is a box in the part properities to lock the position.  So I unlocked it and it works!!!
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf