EEVblog Electronics Community Forum

Electronics => PCB/EDA/CAD => Circuit Studio => Topic started by: negativ3 on June 17, 2020, 11:15:45 am

Title: Rotate schematic symbol 45 degrees
Post by: negativ3 on June 17, 2020, 11:15:45 am

Hi all, this is for a decent looking diode bridge. Any hints appreciated, or do I attempt to draw it up myself?

Title: Re: Rotate schematic symbol 45 degrees
Post by: voltsandjolts on June 17, 2020, 12:20:28 pm

Hah, in 3 years of using CS I never realised you could only rotate in 90 degree increments in schematic!

I suppose it makes sense, otherwise you could get in a pickle quite easily, with pin connections not lining up on the schematic 10x10 grid.

Title: Re: Rotate schematic symbol 45 degrees
Post by: negativ3 on June 17, 2020, 12:37:55 pm

Yea, sod it, it's easier just to make one as a symbol and lay it out incorporating all four diodes in the pcb as well.

Title: Re: Rotate schematic symbol 45 degrees
Post by: T3sl4co1l on June 17, 2020, 01:02:54 pm

How's this?

Tim