Products > Crowd Funded Projects

EEZ Bench Box 3 - Sequel to EEZ H24005

<< < (132/134) > >>

Still, check if Q5 is not shorted.

Q5 is fine, it works now as it should.
Measured Q5 and R29 and both were fine, had to take a closer look to see that cracked solder...


I noticed mention of a 1.8 firmware - this sounds exciting =). Any idea of what will be included in this?

Also - sorry if this is a really basic question, but say I had a LED driver that takes a 0-10V PWM input signal, for dimming (e.g. link).

How would I drive that from the BB3? Which module can I use for that?

Firmware 1.8 incomplete list of tasks can be found here:

If PWM frequency could be low you can try DCP405 module (Function generator, with voltage set to 10V), or you could use SMX46 analog outputs, or MIO168 analog or PWM outputs.

I forgot to mention that 1.8. pre-release (Alpha 2) can be download from


[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Go to full version