New firmware v1.4 is now available for
download. It mainly addresses multiple issues reported by the BB3 backers.
#33 The detected module fault is pushed to standby
#60 Replace SYSTem:CHANnel:SNO? with SYSTem:SLOT:SNO?
#61 Record in event log MP script execution start and end
#67 NTP server connection frequency
#68 Decrease resolution of manual fan speed control
#69 "Encoder & User sw" menu improvement
#70 Inconsistencies in the number of decimal places displayed
#72 Further encoder functionality improvements
#73 Numeric value rounding issue
#74 Disable Down-programmer in low current range
#76 Lightness issue in Dark mode
#77 Retain encoder step (via User SW) setting on power up
#80 DLOG current background highlighting in 2-ch mode
#81 Encoder step size changing improvement
#84 Additional check for parallel coupling
#86 List preview issue
#87 Encoder step values for voltage and current for DCP405
#89 Wrong value in low current calibration graph
#93 Disable User sw menu when Power/Reset control menu is active
#95 USB is disabled after firmware upgrade from v1.0
#96 Garbage in event log on power up without SD card
#97 Current readout in YT-view and dark theme could be more readable
Download procedure is described in
Chapter 13.