Author Topic: Retouch3D  (Read 8759 times)

0 Members and 1 Guest are viewing this topic.

Offline FrankenPCTopic starter

  • Supporter
  • ****
  • Posts: 335
  • Country: us
Retouch3D
« on: April 02, 2015, 06:26:09 am »
Why not just make a Hakko/weller tip set?

https://www.kickstarter.com/projects/1654851065/retouch3d-a-brand-new-way-to-finish-3d-prints

"World's first heated tool to finish 3D prints with variable heat and interchangeable heads designed for specific 3D retouching tasks."
Chinglish poetry: In the hot summer. In the car ran full steam. It tastes strange. For this worry? With this fan will bring you a cool summer. Suitable for all kinds of cars. Agricultural vehicles. Van. Tricycle.
 

Offline Mechatrommer

  • Super Contributor
  • ***
  • Posts: 11534
  • Country: my
  • reassessing directives...
Re: Retouch3D
« Reply #1 on: April 02, 2015, 11:38:44 am »
i've done this from many months ago, ie finishing up 3dprint output with bundled flat tip temp control china 852AD. just make sure you sacrifice that tip for the purpose only because after that it wont be good for normal soddering without extensive abs ash deposit cleanup.
Nature: Evolution and the Illusion of Randomness (Stephen L. Talbott): Its now indisputable that... organisms “expertise” contextualizes its genome, and its nonsense to say that these powers are under the control of the genome being contextualized - Barbara McClintock
 

Offline BloodyCactus

  • Frequent Contributor
  • **
  • Posts: 482
  • Country: us
    • Kråketær
Re: Retouch3D
« Reply #2 on: April 02, 2015, 05:49:55 pm »
hakko make a knife tip. T18-K, 10$!

www.amazon.com/dp/B004ORB8MY

-- Aussie living in the USA --
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf