EDA > DIPtrace

Does anyone use it?

(1/10) > >>

buffalo960:
Does anyone besides me and house91320 use diptrace here?

Mechatrommer:
https://www.eevblog.com/forum/index.php?topic=3468.msg46492#msg46492
https://www.eevblog.com/forum/index.php?topic=3914
count me in, but a total noob.

slburris:
I do, and I like it well enough that I've paid for the standard edition :-)

Scott

500in1:
I also use it. I have purchased the non-profit version (just a hobbyist and student at this time).

After trying Eagle, and DesignSpark, I felt that Diptrace was the most intuitive for me.

A-sic Enginerd:

--- Quote from: Mechatrommer on July 14, 2011, 06:12:06 pm ---https://www.eevblog.com/forum/index.php?topic=3468.msg46492#msg46492
https://www.eevblog.com/forum/index.php?topic=3914
count me in, but a total noob.

--- End quote ---

Ditto.
Totally new to board design. Did a little digging around, including on here, and decided it was the tool to go after first. Using just the free version for now. An upcoming project may have me spending the few bucks to get into the standard version.

Currently have the bulk of my little function generator project schematic done on it. Had to create a couple of components that weren't already in the libs. Was pretty straight forward. Once I finish the power supply part of the design I'll be going to the board layout side of it.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version