Author Topic: Excluding layers from auto-Routing  (Read 2012 times)

0 Members and 1 Guest are viewing this topic.

Offline akis

  • Frequent Contributor
  • **
  • Posts: 967
  • Country: gb
Excluding layers from auto-Routing
« on: November 17, 2013, 09:57:57 am »
I would like to draw a few tracks manually at the bottom, and then tell DIPTrace to auto-route at the top. In the old version the auto-router had an option which layers of the board to use. On the new version there is a "layers setup" dialog that allows me to designate a layer as "plane" and so is excluded from auto-routing, but doing that also turns my pads into rings for some reason. Am I doing this the right way ?
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf