Products > Dodgy Technology

Pokit

<< < (7/9) > >>

Haenk:

--- Quote from: bluey on May 08, 2020, 10:25:20 pm ---I’m confused. The specs say it will do 60V DC 43V AC but the renderings show 110-238V DC.

--- End quote ---

Check the Kickstarter-page, there is a comparison sheet. The raised specs are for the "Pokit PRO", the lower specs are for the "Pokit" (non-PRO).

Still expecting smoke :)

And then - another missed Kickstarter timeframe - delivery May 2020 seems kind of unlikely if they are still in development state.

AVGresponding:
It's difficult to tell from the pictures what those fuses are, but at a guess they're something like a 1210 package.

That would give them a voltage rating of 125VAC/65VDC with a measly 100A interrupt capacity.

https://www.mouser.co.uk/datasheet/2/54/bourns_03262018_SF-1210SxxxW_datasheet-1314529.pdf

Haenk:
Again, that's the standard "Pokit" (non-Pro).

But - they are already listing the spare fuses for the "Pro" (which look OK for 600V 10A):

https://shop.pokitmeter.com/products/pokit-pro-fuse-set

Cyberdragon:

--- Quote from: Haenk on May 09, 2020, 01:26:28 pm ---Again, that's the standard "Pokit" (non-Pro).

But - they are already listing the spare fuses for the "Pro" (which look OK for 600V 10A):

https://shop.pokitmeter.com/products/pokit-pro-fuse-set

--- End quote ---

Are they actual HRC fuses though?

AVGresponding:
From the proportions in the pic those look like ceramic M205's. That's a pretty basic level of protection, and well short of what you get from even a 6.3mm x 32mm, and not even in the same universe (exaggeration) as a 10mm x 38mm.

https://www.mouser.co.uk/datasheet/2/643/ds-CP-0adkx-series-1218961.pdf

Navigation

[0] Message Index

[#] Next page

[*] Previous page