Electronics > Eagle

Autorouting help in EAGLE

<< < (3/3)

jpanhalt:
That will work, but so will setting priorities.  There can be problems when using traces too, as new users may not realize that geometries are not traces (i.e., they cannot be assigned a signal).   So, "traces" in a strict sense must be used.  A polygon is just an easy way to draw such traces* when assigned a priority of 1.

This thread is probably too old to matter.

John

*For home etching,  I used to use a polygon with very narrow (e.g., 0) width to create a negative logo.  Looked fine, until I submitted one to a board house.  The error was that traces were too narrow.

SKY KALAI:
Yeah sir first of all thanks for your reply. you are right. Some weeks ago I learnt and use of restrict layers in EAGLE.  :)

Navigation

[0] Message Index

[*] Previous page