Electronics > Eagle

conditional schematics in eagle ?


Is it possible to do conditional schematics ? I want to be able to build a board that has optional features, and then not include them in the board. I can fully route the board with all the components, then turn them off in the schematic and it'll go away, or worst case do some rerouting,i'd prefer not to have to export them to a new project/schematic. I realise i can just not populate the board in those areas, but i do have some instances where i don't want the tracks/pads to exist.



[0] Message Index

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod