Electronics > Eagle

Deleting Drill "icon" things in Eagle Pro 7.4.0?

(1/1)

Faringdon:
Hi,
When you run the drilllegned-stack.ulp ("run in board") in Eagle pro 7.4.0 it puts the drill "icons" on the PCB.
..ie on the "Drilllegend 01-16" layer

Is it ok to delete all these?

ebastler:
I would simply disable layers 144-146 (via the Layer Display control) to hide that legend. When you generate Gerber files later, these layers will not be included anyway.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version