EEVblog Electronics Community Forum

EDA => Eagle => Topic started by: SuperMiguel on November 17, 2010, 05:23:43 am

Title: Eagle help
Post by: SuperMiguel on November 17, 2010, 05:23:43 am
My first eagle project, trying to make a tic tac toe PCB:

Here is what i want: (the lines were made using mspaint)
(http://img44.imageshack.us/img44/5046/whatiwant.jpg)

And here is what i have:
(http://img233.imageshack.us/img233/8996/whatihave.jpg)


I been trying for a while and can get it the way i want :(

Title: Re: Eagle help
Post by: TheDirty on November 18, 2010, 01:32:19 pm
Sometimes you just can't route it single sided and need jumpers. Upload the .sch and .brd files and I'll see how far I can get with it.
Title: Re: Eagle help
Post by: Waifian on November 18, 2010, 05:45:52 pm
How do you plan to control each LEDs output? In eagle you have to use nets not wires.
Title: Re: Eagle help
Post by: TheDirty on November 18, 2010, 06:05:05 pm
You can see the airwires in his screen cap, he's netted everything, he just need to route it all.

Taking a look at it quickly, do you mind of the 'red wire' leds are turned around?  You might be able to route everything if they are turned around 180.  You just have to remember when placing the components that those LED's are backwards.
Title: Re: Eagle help
Post by: tyblu on November 19, 2010, 06:48:38 am
I gave it a go, and barely got it on a single side.
http://www.ualberta.ca/~tlucas/misc/demo_LEDtictactoe.pdf (http://www.ualberta.ca/~tlucas/misc/demo_LEDtictactoe.pdf)
http://www.ualberta.ca/~tlucas/misc/demo_LEDtictactoe.zip (http://www.ualberta.ca/~tlucas/misc/demo_LEDtictactoe.zip)
You'll want to clean it up or redo it, but it's possible. ;)
Title: Re: Eagle help
Post by: vimark on November 24, 2010, 08:12:14 am
Have it autorouted and it might give you a hint on the routing, Just a suggestion.
Title: Re: Eagle help
Post by: TheDirty on November 24, 2010, 01:32:13 pm
I gave it a go, and barely got it on a single side.
That was really well done Tyblu.

I think it would be easier if the odd LED was turned around 180 degrees, but since the OP hasn't come back to this thread I'm not going to give it a try.
Title: Re: Eagle help
Post by: Slobodan on August 24, 2011, 04:08:16 pm
Could someone provide me with a link for downloading MCP73871.lbr (QFN20) and BQ24210.lbr (WSON10)?
I could not find it on the internet, and i can't make those footprints in Eagle because i suck at software and i hate software.

EDIT: I have found MCP73871.