Electronics > Eagle

Eagle PCB - Layer Stack Settings

(1/2) > >>

Hi all,
Just a quick question. I am trying to set-up a 4 layer board in eagle for production at PCB cart with the following layers:

1. Signal
2. GND
3. VCC
4. Signal

Does anyone know the correct settings? I think its something like (1*2+3*16)?


shouldn't GND and VCC be the outer layers ?


--- Quote from: Simon on January 19, 2010, 10:28:46 pm ---shouldn't GND and VCC be the outer layers ?

--- End quote ---

Not usually, no.
GND and VCC on the inner layers is standard practice.
Advantages are you get physical access to the signal layers, far fewer vias (greater reliability, better controlled signal integrity), no crosstalk between signal layers, better power plane signal integrity (no cutouts for components), and greater bulk capacitive coupling between VCC and GND.
External EMC issues are usually moot. Only in special cases would you have no traces and all plane top and bottom.


I emailed PCB Cart asking for there default stack-up so thought I'd post it here if anyone else was wondering:

Normal layer stack up: 1.6mm thickness/ four layer?
----------------- copper weight
~~~~~~~~~~~ 7628/ prepreg
============= 1.2mm1/1
~~~~~~~~~~~ 7628/ prepreg
----------------- copper weight
If I am correct the layer settings should be: (1+2*3+16) where * represents a core layer and + prepreg.


It does not matter for the PCB fabricators how the PCB software is configured (unless you want to send the work file to them), they need only four gerber files for the copper layers plus solder masks top/bottom and optional silkscreens. Rest is pretty irrelevant, although there might be some recommended practices with particular software where the PCB layers should be located internally. For example in PADS, copper layers are always 1 to n, where n is the number of PCB layers. 1 is the top layer and n is the bottom.



[0] Message Index

[#] Next page

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod