I need help creating a smt connector breakout board.

[dottedquad]

I orinally posted my question at:http://forum.espruino.com/conversations/1593/#comment27325
To sum up what i would like to do is either purchase a breakout board that supports a Hirose DF40C (2.0)-40DS-0.4V (51) or create my own pcb using eagle cad. I seached google and stumpled upon a lot of smt breakout boards with a lower count of pins. As mentioned on the other forum I  probably need to create a custom pcd in eagle cad; however, I have no idea where to begin. Any help is greatly appreciated.

[mamalala]

What exactly do you want to accomplish? Things with such fine pitch connectors are, quite often, also things that require a decent timing/signal integrity. Spreading it out on a breakout board may cause problems.

And as for the board itself, what exactly do you need? Send me an eMail or a PM with the details, and i'll see what i can do.

Oh, and have you thought about soldering the connector to the board later on? Are you able to do that?

Greetings,

Chris

[MarkL]

How about this one?

  http://www.schmartboard.com/index.asp?page=products_partnum&id=62

Available direct from Schmartboard, or through distributors (such as Mouser).