Pads are not displayed correctly

[fxr]

Hello everyone!

I use library SparkFun-LED.lib, and have problem with showing pads in my board place.
As shown on the picture, at Eagle library editor the component look ok, but on the board all pads is very bold.
What am I doing wrong?

[H.O]

In the library, the thickness of the anular ring can either be fixed at certain value or set to zero which allows it to vary depending on your overall design rules. In this case that part is configured to have the design rules set the thickness.

I have not used EAGLE for a long time so I'm afraid I can't give you the exact details on which setting it is that controls this.

[fxr]

SOLUTION HERE - https://www.autodesk.com/products/eagle/blog/what-you-didnt-know-about-eagle-restring/