« previous next »
Pages: [1]   Go Down

Author Topic: Doubt in seeing the dimension of the component in the datasheet  (Read 3005 times)

0 Members and 1 Guest are viewing this topic.

Offline electrowhizTopic starter

  • Contributor
  • Posts: 28
  • Country: in
Doubt in seeing the dimension of the component in the datasheet
« on: June 05, 2018, 10:05:11 am »
The dimension in the datasheet is given with the comma and what it represents? I have attached the image. Tanq in advance
Logged
 

Offline rachaelp

  • Supporter
  • ****
  • Posts: 156
  • Country: gb
Re: Doubt in seeing the dimension of the component in the datasheet
« Reply #1 on: June 05, 2018, 10:14:57 am »
In some places it's common notation to use a comma as the decimal point rather than a full stop. In this case I would say your pad width is 0.50mm, pad height is 1.10mm and your pad pitch is 1.00mm.

Best Regards,

Rachael
Logged
I have a weakness for Test Equipment so can often be found having a TEA break (https://www.eevblog.com/forum/chat/test-equipment-anonymous-(tea)-group-therapy-thread/)
 
The following users thanked this post: electrowhiz
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee