Electronics > Eagle

All symbols and footprints are smashed (v9.x) - how to un-smash?

(1/2) > >>

Hemi345:
I have an annoying issue with Eagle now that I can't figure out.  At some point, all the symbols and footprint 'stuff' like name, value, etc are all separate... they have their own origin/handle to grab and move around. Screenshot below (yellow arrows are pointing to the origins/handles). I sorta remember a setting in the older versions of Eagle that when you right-click you could break apart a symbol or footprint to allow this, but I just don't see that option anymore and can't remember what it was called.  Having origins on all this makes it frustrating to move things around because I keep grabbing the origin of the other stuff instead of the main component.  Not only that, but I have the same issue in board view too! Anyone know how to join all this back together?

Karel:
Right-click on the component and select properties. Then uncheck "Smashed".

Type "help smash" for more info.

ebastler:
I am sure someone with 9.x experience will chime in soon; I am still on verson 7.x.

In 7.x, the "Smash" command (or icon) is used to separate the name and value text from the main object. There is no "unsmash", but you can open the part's properties dialog box (via the "Info" command), and then uncheck the "smashed" checkbox.

Edit: Ah, Karel beat me to it...  ;)

Hemi345:
I don't see a Smashed option in the properties.  Also, the docs say holding shift while the Smashed tool is active will do this too but that doesn't work either.

This seems to have happened on a global level because all components are now like this. 

It seems they're calling this "REPOSITION" now, but the issue remains.

rachaelp:
Hello,

In early v9.x the SMASH command was removed and everything became auto-smashed. This did cause a lot of irritation and complaining over on the official Autodesk EAGLE forum. In 9.3, to correct the issues caused by this, there is now a new way to hide all the handles for the attributes. When the group or info commands are activated there is now a new "Enable Attributes" button on the toolbar at the top. Clicking this enables you to toggle the visibility of the grab handles on the attributes. There is still some improvement needed, it needs to be available in more tools (or everywhere) and it needs to be independent between schematic and board, hopefully they'll do this in an upcoming release.

Best Regards,

Rachael

Navigation

[0] Message Index

[#] Next page