Electronics > PCB/EDA/CAD

12V-5V buck converter layout feedback using TPS54331DR IC

(1/3) > >>

newtekuser:
Using a TPS54331DR as switching IC for a 12V-5V buck converter and need some feedback on the layout. I used the sample layout suggested in the TPS datasheet with some small adjustments.

The stack-up is 4 layer (SIG, GND, PWR, GND).

Attached are the schematic and PCB layout. Thanks in advance!

daisizhou:
https://we.tl/t-RjTRRjgkeH
Here is the complete PCB layout, please check it out

newtekuser:

--- Quote from: daisizhou on December 24, 2024, 11:28:54 am ---https://we.tl/t-RjTRRjgkeH
Here is the complete PCB layout, please check it out

--- End quote ---

Thanks, but I'd like to get feedback on the layout I attached.

daisizhou:
https://www.douyin.com/user/MS4wLjABAAAAsrnydfX_gbCgGmRky_QT9Wb2DWgu3HW4-OZdRTNBeYxiiXZc4KSjrQEkq0Rp1N6v?from_tab_name=main&modal_id=7350684535358590219&vid=7450517367639149834

Please watch this video, you will find the answer you want.

thm_w:
- You don't have the topside ground which they mention in the datasheet.
- D5 should have topside ground or more vias.
- C23 and C27 can move closer to D5
- Feedback trace can be a bit shorter

I'm sure it will work fine as is, but its a fair departure from the datasheet layout.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod