31 mils thick PCB

[Alex Eisenhut]

Hi,
Where do you get small qties of small (1sq in) fr-4 31 mils (0.8mm) thick PCB made?
I've been getting pricing from different places and the prices are between 3 to 20 times the price of getting small 62.5 mils PCB made.
Is dirtyPCBs any good?
Thanks

[Rerouter]

seed studio is good for it, just try and balance out how much copper you have on each side, If you have a solid ground plane on one side and scarce traces on the other they tend to warp a little

[Alex Eisenhut]

Seeed studio. The cheapest one I can find that accepts USD payment.

I looked at a lot of places, but I didn't take notes  , I think Seeed charged a lot for shipping. I'll check again, plus remember: the pieces of paper we use in Canada are worthless these days, which is why I'm shopping around a lot!

[sleemanj]

Is dirtyPCBs any good?

DirtyPCBs is pretty good.  No frills service. 

NB: It's a DangerousPrototypes.com service, see their forum for various discussions about it.

[Alex Eisenhut]

Here's an update I got from OSH Park:

"We're hoping to offer a 0.031" thickness some time in the next few months, since we get a fair amount of requests, but that's probably not until early next year."

 

[wraper]

Elecrow does 0.8 mm without any extra cost.

[zapta]

Elecrow does 0.8 mm without any extra cost.

+1 for Elecrow.

[Alex Eisenhut]

Thanks everyone. Now, to actually design the circuit...

[Bud]

DirtyPCBs is pretty good.  No frills service. 
NB: It's a DangerousPrototypes.com service, see their forum for various discussions about it.

DirtyPCBs, Dangerous Prototypes, TopLoser.... what is wrong with these people, don't they believe in name karma ?