EDA > General PCB/EDA/CAD Discussions

Anyone else using diptrace?

(1/3) > >>

slburris:
I think there's at least one other person who has said they are using diptrace.

I've been blithering on about it in the Altium forum and I figure it's probably better
to start its own topic.

Scott

Mechatrommer:
pro and con compared to altium?

Simon:
I think there is a free version. I gave up with it as it looked a bit complicated for my needs

Mechatrommer:

--- Quote from: Simon on June 26, 2011, 11:02:53 am ---I think there is a free version. I gave up with it as it looked a bit complicated for my needs

--- End quote ---
any suggestion on simpler solution?

Simon:
well there is the simplistic expresspcb software but for something decent and free your only option is KiCad

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version