EDA > General PCB/EDA/CAD Discussions

Circuit Simulation: Where is it going?

<< < (3/3)

ataradov:
Going from 8051/Z80 to MPU + MCU without any other information does sound like an overkill. I would override too until further evidence is provided that it is really necessary.

nctnico:

--- Quote from: louarnold on May 20, 2021, 10:34:16 pm ---OK, folks. You've been very helpful I have alot to think about. Being a software engineer, I like the MPU + MCU solution when its time to redesign. The hardware people will likely override me.  :(

--- End quote ---
It is likely that a single microcontroller may be able to replace the entire board resulting in a lower production cost and lower chances of failure due to less parts. At some point getting near obsolete devices is going to be expensive as well as software maintenance.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version