Electronics > PCB/EDA/CAD
CL, ZNR, CS as Reference Designators?
Scutarius:
Hi,
I have a PCB that has some reference designators that I haven't seen before, just out of curiosity, I was wondering if anybody knows what CS stands for
This PCB has
NTCs as "CL", no idea why
MOVs as "ZNR" (I found that ZNR stands for Zinc-Oxide Non-liner Resistor)
but for "CS" I have no clue
it is SOD-123 diode (marking is "AF") but diodes do have "D" as Ref Des in this particular board.
T3sl4co1l:
CurrentLimiter? Only for inrush, but maybe. CR (crystal rectifier) common enough for diodes, not sure about CS.
Several have it as a zener: https://smd.yooneed.one/code4146.html
Tim
Scutarius:
Thanks, yes, it is most likely a Zener
Sometimes you can tell the region where designers are, earth symbol style on schematic or selection of negative colors (blue VS black) on equipment
Cheers!
TimFox:
My guess for “CS” is “current source”, a two-terminal device or circuit that maintains a reasonably constant current value over a wide range of voltage across it. Does that make sense for the overall circuit?
Scutarius:
Not really, it doesn't make sense in once part of the circuit but in other is used as a flyback diode. (it is actually a bad design overall, some parts doesn't make sense at all)
All ref des start with 0, as R0, D0 etc, and the revision code has a typical SW format, so I assume it most be a software engineer design ...?
Navigation
[0] Message Index
[#] Next page
Go to full version