Author Topic: Dots and Dodges in OrCAD?  (Read 405 times)

0 Members and 1 Guest are viewing this topic.

Offline Pack34

  • Frequent Contributor
  • **
  • Posts: 650
Dots and Dodges in OrCAD?
« on: August 11, 2018, 06:50:52 am »
In OrCAD schematic, is there a setting hidden somewhere to implement "dodges" or "hops"? Meaning that when two nets on a schematic pass over one another that it'll do a little half-circle around the non-connected net to make it abundantly clear that the two wires are not connected.
 

Online Neilm

  • Super Contributor
  • ***
  • Posts: 1377
  • Country: gb
Re: Dots and Dodges in OrCAD?
« Reply #1 on: August 12, 2018, 03:31:04 am »
Not that I am aware of (unfortunately). 
Two things are infinite: the universe and human stupidity; and I'm not sure about the the universe. - Albert Einstein
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf