EEVblog Electronics Community Forum

Electronics => PCB/EDA/CAD => Topic started by: fixit7 on May 21, 2019, 07:54:44 pm

Title: Draw a 555 chip in Geda ?
Post by: fixit7 on May 21, 2019, 07:54:44 pm

I have tried several circuit drawing programs, but Geda seems the easiest.

I want to add a 555 chip but can not figure out how.

I tried add a picture of the chip, but the pic was too small.

Any other ideas?

Title: Re: Draw a 555 chip in Geda ?
Post by: golden_labels on May 21, 2019, 09:16:51 pm

That should be trivial:

• Press the “Add component” button;
• Enter “555” in the filter field;
• Select the chip;
• Press “OK” and place the component.

Title: Re: Draw a 555 chip in Geda ?
Post by: fixit7 on May 22, 2019, 02:18:38 am

Thanks you very much. :-)