How to change the start location of a tool in SolidCAM?

[stoyanoff]

Greetings! I`m using SolidCAM 2018. Every time when the program creates a path, it puts the tool not in the begining of the coordinate system, but on the right side of the stock material. Which is very unconfortable. Can you tell me how to choose or set the starting point of the tool?
Thanks!

[stoyanoff]

I think I did it! After you add the contour object, edit toolpath is available. And there you can change the location of the tool. But this is available only once I think! If you know a better why I`ll be grateful if you share it!
Best regards!