« previous next »
Pages: [1]   Go Down

Author Topic: How to curl the wires in altiium  (Read 2419 times)

0 Members and 1 Guest are viewing this topic.

Offline AhmetttTopic starter

  • Newbie
  • Posts: 1
  • Country: tr
How to curl the wires in altiium
« on: July 31, 2023, 07:01:09 pm »
In schematic library i want to when the two wire is passing in one point one of the wires get curved like in the picture how can i do ?
Logged
 

Offline ejeffrey

  • Super Contributor
  • ***
  • Posts: 3977
  • Country: us
Re: How to curl the wires in altiium
« Reply #1 on: July 31, 2023, 07:11:35 pm »
I don't think you can?  That style hasn't been recommended for decades AFAIK.  The standard style is to just cross wires.  Indicate junctions with a dot, but don't make 4-way junctions, instead offset one of the wires to make a pair of 3-way junctions.
Logged
 
The following users thanked this post: Ahmettt

Offline thm_w

  • Super Contributor
  • ***
  • Posts: 7353
  • Country: ca
  • Non-expert
Re: How to curl the wires in altiium
« Reply #2 on: July 31, 2023, 07:56:55 pm »
Logged
Profile -> Modify profile -> Look and Layout ->  Don't show users' signatures
 
The following users thanked this post: Smokey, Ahmettt

Offline Smokey

  • Super Contributor
  • ***
  • Posts: 2970
  • Country: us
  • Not An Expert
Re: How to curl the wires in altiium
« Reply #3 on: August 01, 2023, 07:42:16 am »
Just don't cross wires. use more ports :)
Logged
 
The following users thanked this post: Ahmettt
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee