Author Topic: Importing image into ultiboard  (Read 3207 times)

0 Members and 1 Guest are viewing this topic.

Offline MCPorcheTopic starter

  • Contributor
  • Posts: 15
Importing image into ultiboard
« on: August 31, 2014, 09:48:24 pm »
Is there a way to import an image into Ultiboard to use as a template?

I want to lay out some LEDs in a particular shape, and doing it freehand would be difficult


Sent from my iPhone using Tapatalk
 

Offline T3sl4co1l

  • Super Contributor
  • ***
  • Posts: 22436
  • Country: us
  • Expert, Analog Electronics, PCB Layout, EMC
    • Seven Transistor Labs
Re: Importing image into ultiboard
« Reply #1 on: August 31, 2014, 10:28:26 pm »
Yes.  Or DWG, or...
Seven Transistor Labs, LLC
Electronic design, from concept to prototype.
Bringing a project to life?  Send me a message!
 

Offline MCPorcheTopic starter

  • Contributor
  • Posts: 15
Re: Importing image into ultiboard
« Reply #2 on: September 02, 2014, 02:47:49 am »
Could you perhaps give me a nudge in the right direction?
 

Offline T3sl4co1l

  • Super Contributor
  • ***
  • Posts: 22436
  • Country: us
  • Expert, Analog Electronics, PCB Layout, EMC
    • Seven Transistor Labs
Re: Importing image into ultiboard
« Reply #3 on: September 02, 2014, 02:53:39 am »
In Ultiboard 11 at least, it's Place / Graphic / Picture..., Select .BMP (presumably, monochrome).

Import is only DXF, actually.  So nevermind the ellipsis.

Tim
Seven Transistor Labs, LLC
Electronic design, from concept to prototype.
Bringing a project to life?  Send me a message!
 

Offline MCPorcheTopic starter

  • Contributor
  • Posts: 15
Re: Importing image into ultiboard
« Reply #4 on: September 02, 2014, 12:45:24 pm »
Ok, cool.  Thanks a lot


Sent from my iPhone using Tapatalk
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf