Author Topic: OrCAD/Allegro: Toggling transparency  (Read 694 times)

0 Members and 1 Guest are viewing this topic.

Offline Pack34

  • Frequent Contributor
  • **
  • Posts: 667
OrCAD/Allegro: Toggling transparency
« on: September 11, 2018, 04:19:28 pm »
Is there an easy way to do this? I typically prefer the transparencies but when concentrating on a specific layer I find it helps to make that layer opaque to verify planning and routing. Or is the intended approach to just hide the unwanted layers and then toggle the visibility back on when you're done?
 

Offline Neilm

  • Super Contributor
  • ***
  • Posts: 1441
  • Country: gb
Re: OrCAD/Allegro: Toggling transparency
« Reply #1 on: September 12, 2018, 07:11:24 pm »
I use Allegro at work, generally I use both approachs depending on exactly what I am doing at any given point. I don't know if it has been introduced in version 17, we are on 16 at work as not all machines would support running 17
Two things are infinite: the universe and human stupidity; and I'm not sure about the the universe. - Albert Einstein
Tesla referral code https://ts.la/neil53539
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf