Electronics > PCB/EDA/CAD

PCB + PCBA in USA or Europe

(1/4) > >>

VEGETA:
Hello,

I used a lot of Chinese companies such as AllPCB, PCBway, and JLCPCB. However, here in Jordan the customs don't believe the BOM and bill coming from Chinese companies in general, therefore I paid a lot for mere 2 boards assembled!

I asked and they told me they believe bills coming from USA or Europe only, otherwise they will estimate it using their own opinion.... and what a freaking stupid opinion and estimation that is!!

Therefore, kindly recommend to me such companies which can do turnkey for PCB manufacturing and assembly for very small quantities. like 3-5 small panels or something similar.

regards

tszaboo:
Eurocircuit does PCBA. Otherwise, you are looking for 800-1000 EUR setup fees.

VEGETA:

--- Quote from: tszaboo on January 10, 2022, 08:54:30 am ---Eurocircuit does PCBA. Otherwise, you are looking for 800-1000 EUR setup fees.

--- End quote ---

I guess Eurocircuit doesn't serve my country.

hmm 800-1000 euro setup? Chinese companies have about 30-100$ setup cost at most so why this much? you sure no one has similar cheap rates?

if not, then Chinese is better for me since no way customs estimation can reach 800 euros xD :palm: :palm:

tszaboo:

--- Quote from: VEGETA on January 10, 2022, 09:22:36 am ---
--- Quote from: tszaboo on January 10, 2022, 08:54:30 am ---Eurocircuit does PCBA. Otherwise, you are looking for 800-1000 EUR setup fees.

--- End quote ---

I guess Eurocircuit doesn't serve my country.

hmm 800-1000 euro setup? Chinese companies have about 30-100$ setup cost at most so why this much? you sure no one has similar cheap rates?

if not, then Chinese is better for me since no way customs estimation can reach 800 euros xD :palm: :palm:

--- End quote ---
It's this much because people in Europe are payed a living wage.
Additionally, if you reserve production in a European EMS, it means they will setup the production line according to your board. You need to pay for the downtime. And we don't race to the bottom.
Though I just looked up a quote from 1 years ago for a personal project, and it was only 460 EUR, so less than from the top of my head.

VEGETA:
I checked Eurocircuits and they don't support assembly for my country. Do you know another USA\European supplier?

All I can hope for is getting a quotation and see how it goes.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version