Electronics > PCB/EDA/CAD

pcb-rnd, Gentoo overlay (sci-electronics/pcb-rnd)

(1/1)

legacy:
version 2.1.1

Elisabeth and I have just created an ebuild (rev C), it has been tested on { ppc, hppa }, and it requires these two patches

besides, it requires these use flags, in /etc/portage/package.use/eda

--- Code: ---sci-electronics/gerbv     doc examples -static-libs unit-mm
sci-electronics/pcb-rnd   -cairo gtk motif -opengl xrender gcode gerber

--- End code ---

The installed programs will come with two GUIs: gtk and openmotif!
If you want opengl hardware support, you need to enable the opengl flag.

edit:
We (at DTB) are not affiliated with Gentoo, but we are unofficial supporters for non-x86 machines.

legacy:
We will try to support future versions of pcb-rnd as soon as released.

ScribblesOnNapkins:
Wow. Thank you for doing this!

Thanks also from our project leader Igor2.

legacy:
we have just enhanced a bit the ebuild (rev E) and added a userflag table.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version