The company itself has been around since 1997:
https://www.kinjipcb.com/company-profile/When you upload the gerber, it will take 5-10min or so just to process it, then you'll see a thumbnail. Properly rendered the internal cutouts on the board.
At that point status changed into "Being reviewed", where it sat for 15min, until it hit approved. I'm not sure if this means they are manually reviewing gerbers?
When you add the $0 PCB to your cart it will go to $5, then when you go to checkout it drops to $0 again.
Tried to add aluminum core PCB but shipping went to $23.
So just ordered a simple test pin header board I was working on.
Things to be improved:
- faster verification
- online instant gerber view
- shipping estimate before reviewing the gerbers