QucsStudio 4.3.1 - simulation problem

[katto01]

Hello,

I am trying to simulate a simple circuit. I get this warning:
"Ratio of adjiacent grids too large (2.09116) at y=0.0220684mm.
=> Simulation might be innacurate"

Q1: is there a way to modify the mesh in QucsStudio 4.3.1?
Q2: Does QucsStudio 4.3.1 have a dedicated  user forum? I googled it but not found one

Thanks

[djsb]

Forum is here

http://qucsstudio.de/forum-en/

Can't answer the question about grids.

[katto01]

Thanks

It looks like the forum does not accept new members. Is this right or I have a connetivity issue?