Electronics > PCB/EDA/CAD
Looking for someone to help me with a PCB design with a STM32 and Canbus
(1/1)
chrisgti:
Looking for someone who can design a PCB for me with an STM32 and Canbus and possibly program it at the same time.
Gyro:
Hi,
Please use internet translate functions, this is an English language forum. Also please do not double post, this is not permitted.
--- Quote ---Find someone to me a PCB design with an STM32 and Canbus and possibly programmed equally.
--- End quote ---
From other post, a bit clearer...
--- Quote ---Find someone me a PCB design with a STM32 and Canbus AND and possibly the software
--- End quote ---
chrisgti:
ok
Kean:
I suggest the best place for this request in future is the Jobs board
https://www.eevblog.com/forum/jobs/
Simon:
--- Quote from: chrisgti on January 15, 2025, 09:30:29 pm ---Looking for someone who can design a PCB for me with an STM32 and Canbus and possibly program it at the same time.
--- End quote ---
So you want someone to do a project for you but you want to dictate the micro controller? why? I have no experience of STM32 but I have looked at the CAN bus peripheral on some of the cheaper ones and it is awful, only 3 message buffers I can't see how it's good for much.
I use a microchip (ex Atmel) micro controller that has 2x bosch designed CAN bus controllers (MTTCAN). Very good, very flexible. This micro controller will also work at 5V which can be useful in some situations. What exactly do you want to achieve?
Navigation
[0] Message Index
Go to full version