EDA > General PCB/EDA/CAD Discussions

Tina-TI model of simple oscilloscope CRT

(1/1)

jpwolfe31:

I am trying to recreate a circuit in Tina-TI.  It is the final x-amplifier for an oscilloscope.  So far, the model works well, with the exception of the output waveform voltages.  I suspect adding a model for the CRT horizontal plates would fix this.  Right now the outputs to the CRT are just open in the model.

Any info would be appreciated.

Thanks

asmi:
One thing that annoys the crap of me is their stupid restriction of only 3 probes if you use any external (non-TI) models in your circuit :box:

mstevens:
Tina is a good product. Tina TI is a limited version of Tina as far as I know. You may be able to do all you need in the full version of Tina, from www.tina.com.

T3sl4co1l:
What would you model the CRT as?

Typically it's just a few pF; if you're having DC bias issues it ain't gonna be this.

Tim

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version