Author Topic: Via in pad - PCB manufacturer  (Read 1144 times)

0 Members and 1 Guest are viewing this topic.

Offline msantos

  • Newbie
  • Posts: 4
  • Country: pt
Via in pad - PCB manufacturer
« on: October 27, 2021, 12:20:26 pm »

Has anyone ever used a PCB with via in pad (capped via with copper)?
I'm using a BGA with small pitched 0.5mm because of this component shortage, even tought it's a 2 layer board but is the only package available, otherwise I'll have to rewrite the firmware.
The via in pad have holes of 0.15mm and a pad diameter of 0.3mm which not a lot of fab houses can do.

Does anyone know of a good (preferably not too expensive) pcb house that can do this boards in Europe?
I got a quotation from china around 200$ for 20 boards, I'm not expecting to find cheaper, but if I could find an EU manufacturer would ease things for me.


Offline jc101

  • Frequent Contributor
  • **
  • Posts: 413
  • Country: gb
Re: Via in pad - PCB manufacturer
« Reply #1 on: October 27, 2021, 04:43:16 pm »
Eurocircuits can do this, choose via filling and it's suitable for via in pad.

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo