Electronics > PCB/EDA/CAD

What laser cutter to purchase ?

(1/5) > >>

diracshore:
Hi all,

I have decided I want a laser cutter to play with, a cheap one from China, but it has to perform reliably and take standard CAD file formats as input. I would like to cut acrylic and if possible sheet metal. Thinking $800-2000 USD.

Looking for suggestions, experience, advise.

Thanks !

mikeselectricstuff:

--- Quote ---a cheap one from China,
but it has to perform reliably

--- End quote ---
Pick one.

Chet T16:
Is that one of yours still on the go Mike?

robrenz:

--- Quote from: diracshore on July 28, 2012, 05:53:25 am ---a cheap one from China, but it has to perform reliably

--- End quote ---

Isn't that an oxymoron?  :D

mikeselectricstuff:

--- Quote from: Chet T16 on July 28, 2012, 11:16:01 am ---Is that one of yours still on the go Mike?

--- End quote ---
I've hardly used it - the controller is too flaky - there are some files that make it just hang. One of these days I may replace the controller...

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod