Where to find low cost custom bezels for aluminum enclosure?

[Martin F]

Hi all,

We’ve got an extruded aluminum enclosure with custom cut end plates. When we screw in the end plates we find that there is a small gap sometimes - and even when there isn’t, the line where the enclosure and end plate meet is not visually appealing.

We’ve though about ways to “hide” this - eg rubbers, bezels or similar. Any ideas for what to use in our case? And where custom made solutions can be made at low cost?

Thanks!

[kosine]

Something like this might work:

https://uk.farnell.com/hammond/1455pbtrd/enclosure-1455-bezels-red/dp/1415136

Just need to add some laser cut end panels.

[Martin F]

Thanks for the tip! Our entire enclosure is ~3$ so perhaps we're underestimating the cost of the bezels relatively :-) but great page!