Products > Embedded Computing

Blank upload from PIC16F15376 Curiosity Nano


I have tried to upload the memory from the nano board and get only zeros for all SFRs; config bits upload ok. So does the prog memory, I think - it's all in hex!
Any ideas why this would be?

[using Win8.1Pro (32bit), MPLAB X IDE v5.25]

mm.. what do you want to do exactly? I don't think you can read the ram content from the device, as you can read the program memory once it's programmed

I just wanted to see if TRIS, ANSEL and so on were as I'd expected.

I thought I could just read them back into MPLAB from the running MCU but apparently you need to be in debug mode.

Yup, or you can dump the content over UART or something like that


[0] Message Index

There was an error while thanking
Go to full version