Products > Embedded Computing

Blank upload from PIC16F15376 Curiosity Nano

(1/1)

PerranOak:
I have tried to upload the memory from the nano board and get only zeros for all SFRs; config bits upload ok. So does the prog memory, I think - it's all in hex!
 
Any ideas why this would be?
 
Thanks.


[using Win8.1Pro (32bit), MPLAB X IDE v5.25]

JPortici:
mm.. what do you want to do exactly? I don't think you can read the ram content from the device, as you can read the program memory once it's programmed

PerranOak:
I just wanted to see if TRIS, ANSEL and so on were as I'd expected.

I thought I could just read them back into MPLAB from the running MCU but apparently you need to be in debug mode.

JPortici:
Yup, or you can dump the content over UART or something like that

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version