Electronics > FPGA

A FPGA Audio System in raspberrypi size and open source later.

(1/5) > >>

antercreeper:
Still some works are not done and need to fix. Will be opensourced after finishing these.

antercreeper:
Welcome for any suggestions. ;)
Q&A:
1. Why not DDR?
A: because you need to pay for those analog things if you flows ASICs.(only SRAMs, standard cells, normal IOs and PLLs.) This FPGA is ready for validations before making ASICs.
2.

antercreeper:

Right up corner is for Bluetooth module, nRF5340 + CSR8811, support both Bluetooth classic and LE Audio(espressif doesn't support LE audio, and dual band bluetooth.).
It takes much money(about $10 for 1 pcs), and i am sure I will populate only once and never again :'(

antercreeper:

Old version, those mistakes have been fixed in the new version. |O

xvr:
Seems to me it will be quite costly for DIY niche  :(

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod