« previous next »
Pages: [1]   Go Down

Author Topic: ATF22v10b outputs oscillate  (Read 1231 times)

0 Members and 1 Guest are viewing this topic.

Offline c64Topic starter

  • Frequent Contributor
  • **
  • Posts: 297
  • Country: au
ATF22v10b outputs oscillate
« on: January 20, 2022, 05:34:13 am »
I programmed few of them and they all have same strange behavior. I have test PCB to test if they work correctly. No long wires, traces ~5cm long, solid ground, 4 layers, decoupling. After switching inputs for few seconds some outputs suddenly start oscillating in the range 3-5v at about 400kHz. Well, technically it's withing TTL levels but still strange

Part number is ATF22V10BQL in PLCC package. I program them using arduino/afterburner. I did conditioning (writing all 0) before programming.
Logged
 

Offline Beta_vulgaris

  • Regular Contributor
  • *
  • Posts: 68
  • Country: 00
Re: ATF22v10b outputs oscillate
« Reply #1 on: January 20, 2022, 07:36:19 am »
Pin 4 (DIP, PLCC pin 5) Power Down not disabled?
Logged
Electronics, Geospatial, Aerospace
Programmable Logic Devices (PLD) Programming Algorithm Preservation
 

Offline c64Topic starter

  • Frequent Contributor
  • **
  • Posts: 297
  • Country: au
Re: ATF22v10b outputs oscillate
« Reply #2 on: January 21, 2022, 03:29:54 am »
It doesn't have power down pin. Power down is automatic and can not be disabled (AFAIK)
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee