Electronics > FPGA

Does anyone know how many times an Altera MAX II CPLD can be reprogrammed?

(1/2) > >>

JoeN:
I read somewhere a while back that these devices are severely limited in their reprogrammability.  I am doing a hobby project now with a EPM240 and I have reprogrammed it probably 30-40 times.  I know there are ways of simulating your design prior to programming, but I am not particularly sophisticated with Quartus.  Additionally, my design is a state machine that does a lookup on an EEPROM and based on the character looked up then does two more lookups on the EEPROM and then sets outputs.  Because this design is sequential in nature and relies on that EEPROM for data, I think simulation would be difficult, so I am just incrementally making changes in my design, programming the IC, and checking results against what I expected.  Since all it does is run an LED display, I am not too worried if there is a one-clock glitch or two in there, no one will ever see it.  Things are going nicely, but I am worried about frying the chip.  How many times is an EPM240 reprogrammable and will it fail silently or with an actual error in Quartus?  I tried to research this on Google but there is too much noise and everything I have found just states that MAX IIs use flash and are reprogrammable, but without saying how many times.  Does anyone have any information to share?  Thank you.

free_electron:
a few hundred times at least.

amyk:

JoeN:

--- Quote from: amyk on June 16, 2014, 01:38:29 am ---

--- End quote ---

Thank you.  Any idea why Altera would specify a max and not a minimum or typical?  I don't think I have ever seen a value specified that way before.  That seems as if to say "we don't guarantee anything about the device being reprogrammable any particular number of times.  Good luck."  Has anyone had good or bad luck reprogramming them or is what I am doing so out of the ordinary nobody knows?

JoeN:
Interesting, I found a 2005 datasheet with it specified as a minimum:

http://resalpes.grenoble.cnrs.fr/tutorat/vhdl_altera/altera/max2_mii5v1.pdf



I will consider this a minimum.  I think they mean to say "you should consider 100 writes as a maximum though a few more may work out for you if you are lucky."

I think I will have my bugs worked out before I hit 100 and I can always desolder this chip and drop another one on my board if I end up frying the current one.  I got these cheap from a Chinese seller.  They are working well, though.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version