Electronics > FPGA

Simulating ISE 14.7 in Modelsim

(1/3) > >>

ali_asadzadeh:
Hi,
I have a very basic project in ISE, I'm using an IP core for generating a 96MHz clock from a 50MHz input, and use it to blink some LED's and generate a second CLOCK on another IO, the project works perfectly fine, Now I want to make simulation in Modelsim, the Modelsim lunches, But it would complain with these errors


--- Code: ---# ** Error: ipcore_dir/Clock96MHz.v(77): Module 'IBUFG' is not defined.
# ** Error: ipcore_dir/Clock96MHz.v(109): Module 'PLL_BASE' is not defined.
# ** Error: ipcore_dir/Clock96MHz.v(128): Module 'BUFG' is not defined.
--- End code ---

How should I solve the problem, the ISE project is attached for your reference.

emece67:
Have you generated/compiled the libraries for ModelSim using compxlib?

ali_asadzadeh:

--- Quote ---Have you generated/compiled the libraries for ModelSim using compxlib?
--- End quote ---
I have just compiled the project with this right click menu


I do not know How to do compxlib!?

ali_asadzadeh:
emece67 is this the way to compile libs?

emece67:
The last time I did that it was with tool compxlib, that launched a Wizard where you selected the target simulator and language. Unfortunately, this was years ago.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version