Electronics > FPGA

Spartan3e with BPI flash

(1/1)

pepe:
Hello,

i have a board with XC3S250e, with a paralel NOR flash glued on its BPI interface. I am trying to program this memory using Impact in ISE 14.7, created an MCS file from the binary using promgen, with with option -bpi_dc parallel, this was just OK (at least as far as i can tell )
But. Tried to add this flash image in Impact after initializing the chain, selected the above MCS file but it only allows me to select SPI PROM as a target device:


I could not really figure out why it does not allow me to select BPI memory, any ideas?

thx,
pepe

Navigation

[0] Message Index