Electronics > PCB/EDA/CAD
Draw a 555 chip in Geda ?
(1/1)
fixit7:
I have tried several circuit drawing programs, but Geda seems the easiest.
I want to add a 555 chip but can not figure out how.
I tried add a picture of the chip, but the pic was too small.
Any other ideas?
golden_labels:
That should be trivial:
* Press the “Add component” button;
* Enter “555” in the filter field;
* Select the chip;
* Press “OK” and place the component.
fixit7:
Thanks you very much. :-)
Navigation
[0] Message Index
Go to full version