Hi,
How to put the bootloader onto a blank atmeg, what's needed and how to do it.
How to program after the bootloader is on the atmeg, what's needed and how to do it.
I know its about the shield, but people want to go from the shield to a board, using the shield as a prototyping board for the software, and then want to take that software onto a dedicated project board, and that's where a lot of people give up because there not sure of what or how to do it with or without a bootloader. And how to continue icsp after it's there.
How to take the program from the shield after development and put it onto a prototype pcb, what's needed, how to program on board and whats needed.
Something up there you might want to include.
Mr Smiley