Author Topic: Digital_and_Analog_Ground  (Read 3010 times)

0 Members and 1 Guest are viewing this topic.

Offline Write_to_SmokegeneratorTopic starter

  • Regular Contributor
  • *
  • Posts: 52
  • Country: at
  • enthused hobbyist
Digital_and_Analog_Ground
« on: September 11, 2012, 07:06:30 pm »
Hi

I've run into a Small Problem.

Currently I'm designing a Circuit where I have a Digital and an Analog Ground. The Problem is to Connect both because if I use the AGND Symbol, the DRC puts out some warnings, normally i would ignore this, if I would print the circuit at home, but this circuit will be manufactured professionally.
My current sollution to this Problem is really dirty I just use a 0 OHm Resistor but I don't want to use this.
I would appreciate some help ;)

Wondering about my Username have a look at:
http://www.finkewitz.de/uwe/witze/ANSIASM.txt
 

Offline Psi

  • Super Contributor
  • ***
  • Posts: 9889
  • Country: nz
Re: Digital_and_Analog_Ground
« Reply #1 on: September 11, 2012, 10:56:19 pm »
Greek letter 'Psi' (not Pounds per Square Inch)
 

Offline Write_to_SmokegeneratorTopic starter

  • Regular Contributor
  • *
  • Posts: 52
  • Country: at
  • enthused hobbyist
Re: Digital_and_Analog_Ground
« Reply #2 on: September 12, 2012, 06:56:38 am »
Thanks, helped a bit I'll that workaround with teh renaming, maybe this will work, if not i'll stick with the 0 OHM Resistor.
cheers.
Wondering about my Username have a look at:
http://www.finkewitz.de/uwe/witze/ANSIASM.txt
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf