Hi all
I'm looking for a supplier who can look after the tooling and production of a small plastic part for a consumer electronics product. The part itself is only ~25mm diameter, and the material needs to be either PC or PE.
Has anyone dealt with suppliers either in Europe or the Far East (well, anywhere really although cost is of course an important factor!) who deal with relative novices like me? I have the model ready to go which has been prototyped (with a 3D printer) and has suitable draft angles etc.
I'll probably be looking at batches of 1,000 units at a time, so not exactly huge but too much for 3D printing!
If anyone has done this sort of thing before and could provide a recommendation I'd be really grateful